Gun Fight
- Install EasyCoinup; I had one for it but I had to use it for Star Wars after I destroyed the first one by using too much heat while soldering the wires to the pig tails on the EasyCoinup (they are very very delicate)
Spy Hunter
- Check the board voltage. On startup the screen does horizontal scroll for a few seconds. Not sure if this new: the screen takes a few seconds to warm up so it could have been happening all along and I wouldn’t have noticed until I was turning the machine off/on during other fixes and the warmed up screen would show up fast enough to reveal the problem. I replaced the potentiometers on the linear power supply so I should make sure I’m getting the correct voltage at the PCB to be safe.