2015 – August Purchased this cabinet in very good condition from a fellow collector. Attempted to replace some capacitors to fix an issue with tube going blank after a few seconds immediately after machine was turned on. This problem goes away after the machine has warmed up. Initially it looked like the capacitor replacement had… Read More »
2013 – November Purchased on eBay, in fully restored condition 2014 – January Had a minor issue with loose chips that caused a ‘streak’ on the screen and resetting during game play. This was likely due to it being shipped from Minnesota. This was fixed by re-seating the chips. 2023 – January I noticed I’m… Read More »
2016 – December Purchased from a seller through Pinside Marketplace 2016 – December Purchased playfield protector 2017 – January LED lighting upgrades
2016 – December Purchased on eBay 2016 – December Added playfield protector 2017 – January LED lighting upgrades
2015 – September Purchased from a local seller 2016 – December Upgraded with LED bulbs 2022 – August Playfield lights were flashing and then going out during game play and attract mode. It turned out to be a relay, where a set of metal blades needed to be adjusted to properly make contact and illuminate… Read More »
2018 – October Purchased from a seller in Minnesota
2013 – July Purchased from a seller in California
2017 – April Purchased the Asteroids Deluxe cabinet from a seller on eBay. Purchased a replacement bezel shroud to restore the blue-screen effect. Also purchased an Asteroids Deluxe Monitor Sheet as a fall back in case that didn’t work. 2017 – June Purchased a Braze Asteroids Deluxe Multi-game High Score Save Kit to keep scores… Read More »
2014 August Purchased Red computer space from a local friend 2022 October Found that the ship would get blurry or scrambled when being rotated. At other times, it would rotate but it would turn really fast, making it too hard to control the ‘English’ on the shots where you can direct them into the enemy… Read More »
Gun Fight Install EasyCoinup; I had one for it but I had to use it for Star Wars after I destroyed the first one by using too much heat while soldering the wires to the pig tails on the EasyCoinup (they are very very delicate) Spy Hunter Check the board voltage. On startup the screen… Read More »